Tag Archives: sealant performance
BTG Labs’ Chief Scientist Dr. Giles Dillingham recently presented at the 40th annual meeting of the Adhesion Society. An elected Fellow of the Adhesion Society, Dr. Dillingham has been contributing to this community since 1980.
Giles’ presentation, “Control of Cleaning Processes to Maximize Sealant Performance,” focuses on quantifying parts washers and sealant processes. The importance of monitoring cleaning processes in preparation for sealing is becoming increasingly important in the automotive industry, as sealant processes such as such as FIPG (formed in-place gaskets) are replacing traditional fasteners. However, when sealing, the surface must be clean and clear of contaminants in order to guarantee the bond.
As FIPG relies on properly made bonds, contaminants preventing the success of those bonds must be monitored and properly expelled. There is a wide range of assembly liquids that can interfere with the bond of FIPGs–cutting fluids, die lubes, corrosion inhibitors, as well as particulates generated from casting and machining. This paper shows the importance of quantifying parts washers in order to ensure the part is properly prepared to bond. An engine casing was cleaned in two different parts washers. After each wash, Surface Analyst measurements were taken across the engine casing. Figures within the paper show different measurements and the inconsistency throughout the casing from just one parts washer. Some areas showed low contact angle (indicating a successful wash) while others showed high contact angle (indicating an improper wash). …Read More